1, to establish the load of the anti-static floor with the net weight of the core machine equipment of all the machines and equipment in the main room as the standard, so as to prevent the permanent bending or damage of the calcium sulfate anti-static floor board caused by some machines and equipment too heavy.
2,
Anti-static floor The hazards of external ecological environment regulations change little. And it is not easy to have obvious expansion joints because the working temperature of the calcium sulfate anti-static floor is too high or too low, that is to say, when the temperature of the main room is slightly higher, the anti-static floor will expand and cannot be disassembled and replaced; When the temperature is low, anti-static calcium sulfate anti-static floor the electric floor shrinks, resulting in a loose feeling. Anti-calcium sulfate anti-static floor The shrinkage of the electrostatic floor under the influence of the environment should be less than 0.5mm, and the tensile strain of the surface should be less than 0.25mm.
3. The total area (or number of pieces) of the anti-static floor and various parts (1:3.5, 1:5.5) of the standard preparation of the computer room infrastructure project are required to be accurate, and the capacity is set aside to prevent consumption or emergency shortage.
Install the whole anti-static floor on the girder connected by the steel bars. After calibrating the anti-static floor, its carrying capacity must be more than 1000kg/m2, and the centralized load in any area of the anti-static floor should be more than 300kg. When the load of 300kg is loaded on the loading point with a diameter of 6cm, The tensile strain should be less than 2mm and never permanently bent. The adjustable fulcrum should be able to bear the vertical load on the basis of 1000kg anti-static floor, and the surface should have certain wear resistance. Electrical characteristics are usually system resistors, electrostatic voltages, and surface resistors. The system resistor should be 105-108, when the temperature is 211.5℃, the relative humidity of the air is 30%, the electrostatic voltage of the anti-static floor should not exceed 2500V, and the surface resistance value should be 105-108.
4, many calcium sulfate anti-static floor manufacturers produce and process the type and quality of anti-static floor, as well as a variety of technical parameters. Anti-calcium sulfate anti-static floor The technical features of the electrostatic floor refer to its physical and electrical properties. The physical properties are important and the bearing capacity and wear resistance are fully considered.
5, stainless steel plate after the process, the surface will show a completely different hue. At present, the surface of the stainless steel plate has long been successful to get a variety of colors such as brown, dark blue, light yellow and red. After treatment, the application of stainless steel plate in the decoration design industry will be more common.
